Standard U-Joint Cover for 5.060" Driveshaft Tube O.D.

DRIVE SHAFT COVER SHELL 7.625 BELL X 5.940 MOUNT	2
MOUNT PAD 4.720 I.D. X 5.940 O.D.	4
6" x 6" ZIP-LOK BAG	2
5/8" BLACK PLASTIC PUSH-PLUG	2
M5 HALF-HEX NUT-SERT	12
M5 X 0.8 X 14mm SOCKET HEAD SCREW	12

For Driveshaft Mounted (D suffix) part numbers:

Step 1. Clean the mounting area to remove all loose dirt, surface rust and grease residue. Proper cleaning allows the mount pads to firmly grip the driveshaft tube.

Step 2. Using a straight-edge & marker, draw a straight line from the u-joint grease fitting(s), up the driveshaft long enough to be visible when the cover is mounted. This line will be later be used to drill an access hole to service the u-joint (see below).

Step 3. Affix the 4 provided mounting pads over the 2 attachment bars in each of the cover halves.

Step 4. Place the cover halves over the drive line, rotate as needed to accommodate balancing weights. Properly align the 2 halves using the "Post & Hole"  locating feature before tightening 

Step 5. Using a 4mm hex (Allen) driver, tighten the 12ea. M5 x 0.8 captive socket head screws. Do not overtighten, simply snug the fasteners as you would on any other lightweight cover.

* When installed properly, the cover will flex but not move on the mounting surface. Test for firm mounting by tugging on the open bell. Additional (tighter) mounting pads can be purchased separately if desired.

To access grease fittings facing driveshaft with cover in-place

Step 1. Using the mark from Step 2 above, visually align and mark a spot on the cover above and in-line with the zerk, on the sloping section of the cover.

Step 2. Using a 5/8” (15.75mm) diameter drill bit on slow speed, drill an access hole on the marked spot. *Flat bladed wood bits work best.

Step 3. Place the provided 5/8” diameter plug(s) into the access hole(s) in the cover.